



MMT all glued in. AP mated right up to the BT. If I did this all again, I'd likely just skip the kevlar harness.
Instead of adding epoxy inside the body, I put it on the top of the two CR's and shoved it in and let it run out to make the joint. Would up making a mess, and nearly glued the aeropack to the BT.
I took the cap off, cleaned up the epoxy with acetone, then covered the aeropack in vaseline and and screwed it back on. It seems to have done the trick, but next time, I'm just putting the epoxy in the tube like i've always done before.